Archive of ' Dust Collector'
What to Think About When Doing Your Dust Collection Design
In my first shop, which was my apartment bedroom, I had no dust collection except for vacuuming afterwards. This sucked. Literally. Imagine…cutting boards and then leaving the room, closing the door, and waiting for the dust to settle. It wasn’t a good way to encourage more shop time.
So let’s assume you want some sort of dust collection system…even if just eventually.
Read more »
“Installing a permanent dust collection system is too hard so I just use flex duct and connect it to the machine I’m using”. Sound familiar? Well that’s how a lot of woodworkers think, not feeling like an HVAC expert or very interested in dealing with sheet metal ductwork. But I bet you’d like to have a dream dust collection system in your woodshop. Read more »
How to Get True Set-it-and-Forget-it Filtration for Your Dust Collector.
In the previous post, I told you about how I thought my dust collection system was good enough and kept workstations clean, until I noticed a layer of fine dust all over the dust collector and the surrounding area. This made me realize that while the system is picking up fine dust, it’s also spraying it all over the shop.
Fine dust stays suspended in the air and moves around at even low air speeds so for sure it’s making its way back to my nose.
I decided to dig even deeper into my own system, and make it more like systems I’ve designed for larger shops. There is a balance of cost and performance, but if you make the right choices you can get a kick-butt system for relatively low cost, and upgrade in the future as your funds allow.
It’s not often you think about your dust collector filter, but without a good one you aren’t accomplishing what your dust collection system is entirely meant for: dust extraction and containment. Read more »
I thought my dust collector worked pretty well until I was emptying the lower dust bag and noticed something. It makes total sense, but I just didn’t really think about it before.
I’ve always had the ultimate dust collection system as my goal, and have several improvements on my list. Enlarging the dust ports from 4” to 6” on my jointer, making a dust extraction blade guard for my table saw, and increasing the duct drop size to my drum sander are the main ones. But now I’ve started to rethink the “back end” of the system woodworkers don’t normally worry about.
Read more »